Yeah, I know -- if you read my report on the HJC Sy-Max II helmet latch failure, I said Iíd be looking for another brand of helmet.
But then I heard about the Sy-Max III and after an exchange of e-mails with the engineers at HJC, which included some detailed pictures of the revisions made to the latch anchor points (see below), I pulled the trigger and bought one.
My excuse? We want to make sure youíre up to date on the changes, that way you can make an informed decision on your next helmet purchase!
So, with both the Sy-Max II and III in my possession, I took to the road to do a side-by-side comparison.
My focus was on comparing noise, ventilation, turbulence, eye port visibility, chin bar and face shield operation, since Rick (and Burn) would be covering everything else in detail.
Each helmet was worn twice on the same route while riding my 2002 BMW R1150 GS (report) with the stock windscreen and my 2000 BMW K1200 LTC with the "barn door" windscreen.
The route consisted of slow speeds though the neighborhood; stretches at 50 MPH (80 km/h) and 65 MPH (105 km/h) with a 10-15 MPH (16-25 km/h) headwind when traveling in one direction at the higher speeds. .
The Sy-Max III is just a little bit quieter than the Sy-Max II. I could tell when the top vent was open, but the noise increase was negligible.
I could definitely feel air flowing over the top of my head from the top vent, but only when riding the LT...of all things.
I did find the button that opens and closes the vent a real pain to find with a gloved finger since itís so darned small. Of course, thereís a lot of air flowing in from under the helmet, making it very hard to determine if the chin bar vent is doing anything at all. Note: I intentionally did not wear any type of head wrap so as to better feel any air flow.
Iím pleased to find that the Sy-Max III does a better job in smoothing out the "dirty air" from vehicles ahead of me at higher speeds.
The vision out the top of the eye port has been greatly reduced, but since I ride in an upright position, this is of no concern to me.
The vision out the lower part of the eye port is the same as the Sy-Max II. What is different is amount of space between my chin and the rotating chin bar; there must be almost another 1/2" (13 mm) more room. This is obvious when you put the two helmets side by side with the chin bars in the up position as the Sy-Max III is taller overall.
Yippee!!! They moved the tab on the face shield back towards the center! This was a real disappointment on the Sy-Max II for me, since the face shield would always twist and flex when raising or lowering and required an extra downward tug on the right side to insure it was fully closed and water-tight.
But...I noticed thereís no half-click opening for preventing fogging, perhaps because itís equipped with the mounts for a Pinlock insert, which I donít care for.
While Iím talking about face shields, let me say that I happen to love the internal sun shades that are becoming more common in the modular helmets. Even though I wear sunglasses (for which there is plenty of room), for those times when Iím headed directly into the sun, the internal sunshades are a blessing.
As far as adjustability of the shade is concerned, for me itís either fully way up or fully down so itís not important for me to vary its height.
More: HJC Sy-Max III Review (includes Owner Comments).
Note: For informational use only. All material and photographs are Copyright © webWorld International, LLC - 2000-2012. All rights reserved. See the webBikeWorld© Site Info page. Product specifications, features and details may change or differ from our descriptions. Always check before purchasing. Read the Terms and Conditions!